- P155_001_D09_SS1_60C_procedure Summary - 
Instrument Type: RSAG2

 - Step	1) Conditioning-Transducer : 
Transducer Mode Switching: On Configuration  Override
Normal force transducer mode:  FRT is selected
Motor State / Equilibration Delay : Off Transducer Zeroing / Range Switching: On Range  Override

Range selection High range
Auto range: On 
Transducer zero time Standard
Zero normal force: On

 - Step	2) Conditioning-Sample : 
Temperature 60 °C Inherit Set Point: Off 
Soak Time 200.0 s Wait For Temperature: Off 
Gas Source No change
Maintain LN2 Fill Enabled: Off 
Equilibration: Off

 - Step	3) Other-Axial : 
Temperature 60 °C Inherit Set Point: Off 
Soak Time 0.0 s Wait For Temperature: Off 
Duration 10.0 s 
Motor direction Compression is selected
Constant linear rate 0.063mm/s
Maximum gap change 1.0 mm 
Sampling Linear is selected
Sampling rate 100pts/s
Save image: Off Override averaging time: Off Enabled: Off Enabled: Off Enabled: Off

 - Step	4) Oscillation-Amplitude : 
Temperature 60 °C Inherit Set Point: Off 
Soak Time 300.0 s Wait For Temperature: Off 
Frequency 1Hz
Logarithmic sweep
Strain % 5.0e-3 to 3%
Points per decade 10  
Acquisition Mode:  Correlation is selected
Delay cycles 2  
Delay time 1.0 s 
Frequency based correlation: On Save waveform (point display): On Save image: Off Iterative Strain Adjustment: Off Use additional harmonics: On Fundamental 3rd Harmonic Enabled: Off Enabled: Off Enabled: Off

 - Step	5) Other-Axial : 
Temperature 60 °C Inherit Set Point: Off 
Soak Time 0.0 s Wait For Temperature: Off 
Duration 10.0 s 
Motor direction Tension is selected
Constant linear rate 0.063mm/s
Maximum gap change 1.0 mm 
Sampling Linear is selected
Sampling rate 50pts/s
Save image: Off Override averaging time: Off Enabled: Off Enabled: Off Enabled: Off

 - Step	6) Conditioning-Sample : 
Temperature 20 °C Inherit Set Point: Off 
Soak Time 120.0 s Wait For Temperature: Off 
Gas Source No change
Maintain LN2 Fill Enabled: Off 
Equilibration: Off